Difficulty
Moderate
Steps
2
Time Required
01:00:00
- Boss BD-2 Blues Driver Mod 2 steps
In Progress
This guide is currently being written. Reload periodically to see the latest changes.
Private
This guide will not appear in search results and can only be viewed by team members!
-
-
Start by sorting out all the parts in the kit, the parts list above will help!
-
Open up the back and take a look inside. There are three circuit boards. The main board in the picture to the left, the control board which is connected to the control pots, and a tiny board that only houses the LED.
-
We will need to get to all three boards so the control knobs and nuts holding the pots will need to be removed as well. There is no need to disconnect the input or output jacks.
-
-
-
Expose the top side of the circuit board and find the parts that need to be removed - and start removing them!
-
Remove D3 Diode, D7 Diode, D8 Diode, D9 Diode, D10 Diode, C1 EL Cap, C7 EL Cap, C6 EL Cap, C12 EL Cap, C13 EL Cap, C15 EL Cap, C14 Film Cap, C10 Film Cap, C21 Cer Cap, C23 Cer Cap, C26 Cer Cap, C20 Cer Cap, C25 Cer Cap
-
The C100 Film Cap to remove is located on the smaller board.
-
On the LED board the longer lead goes on the same side as the red wire.
-
